Reply To: Help with Icons

Home Forums Sticker Design Forum Help with Icons Reply To: Help with Icons

#26343
Brittany Berry
Participant

So I’m going to try to explain this further. I load the mat into the machine. While it’s cutting, it seems fine on the entire left side and right side. But the lower middle portions of the sheet, it’s like it’s cutting too far to the left no matter what I do. So basically the lower right quarter of the page is funky. I started to calibrate, but the website said if it isn’t the entire sheet that’s off, then calibration is not the issue. Maybe I need to contact Silhouette themselves.

Scroll to Top